•Connect fill hose (with 90 elbow) to either the HOT/COLD water inlet valve located at the back of the washing machine, tighten moderately. (remember to install the “cap/plug” on the inlet valve not being used)

•Connect the opposite end of the hose directly to the body of the quick connect. Fig. F

•Attach the quick connect directly to the faucet adapter, by pulling the outer collar (ring) downward while pushing the quick connect upward onto the faucet. Release the outer collar (ring) and the quick connect will lock into place.

Fig. H

•Slowly open the water supply line and check for any sign of leaks at all water connection points.

•If leaks occur, immediately close the water supply and effect the necessary repairs and/or replace ment of any/all defective connections. If you are unable to effect suitable repairs yourself, call our toll free CUSTOMER HELP LINE at

"1 800 26 DANBY and ask for assistance.

NOTE: Once the water supply line to the machine

Permanent Hose Installation (dual hose)

If your washing machine is to be permanently installed both fill hoses are required. The following accessories are not required for permanent installation applications;

•Water Inlet Hose Quick Connect.

•Faucet Adapter.

•Water Inlet Valve Cap/Plug.

We recommend that you store these items in a safe place for future use, in the event there is ever a need to change your installation method.

Connecting the Water Inlet Hoses:

•Install a rubber washer into each end of both fill hoses.

•Connect the both fill hoses (with the 90º elbow) respectively to both the HOT & COLD water valves located at the back of the washing machine and tighten moderately. Fig. G

G

Water Supply

is open, the inlet hose is pressurized. (even when

Hot Water

Faucets

the water supply is closed immediately thereafter)

NOTE: Failure to relieve (release) hose pressure before attempting to disconnect the hose from the faucet can result in back pressure over-spray.

Cold Water Connection

Connection

WARNING: Incoming water temperature can be very hot and back pressure over-spray can cause severe burns and/or scalding.

NOTE: To relieve (release) hose pressure, close the water faucet. Press and "Hold" the "red" (pressure relief) button located on the front (body) of the quick connect until the flow of water stops.

Fig. F

When the flow of water has stopped, the hose pressure is released and it is now safe to disconnect the hose from the faucet adapter.

F

Outer

Rubber Ring

Collar

Pressure

 

 

Connecting

 

 

Relief Button

 

 

 

 

Nut

 

 

 

 

 

 

Water

 

 

 

Inlet Hose

Water Mixing

Water Inlet

Valve

Hoses

H

Outer

Collar

8