TROUBLE SHOOTING
PROBLEM | CAUSE | SOLUTION |
|
|
|
Fire burns with a yellow | 1. Insufficient combustion air. | *Adjust the air inlet damper. |
flame. Fuel builds up in |
| *Check for blockage of air intake both inside as |
the burn grate. Window |
| well as outside. |
gets real dirty quickly. |
| *Confirm proper placement of burn grate. |
| *Inspect and clean burn grate. | |
|
| |
|
|
|
| 2. Fuel | *Inspect fuel for amounts of fines and debris. |
|
| *Change to dry clean fuel. |
|
| *Use high quality premium grade fuel. |
|
| *Adjust or fine tune feed rates. |
| 3. Air Leaks | *Ensure glass and gasket seated properly |
|
| *Ensure door is close and latched securely |
|
| *Check ash pan and gasket, secure and tight. |
| 4. Combustion Fan | *Check and clean ash build up on fan propellers |
|
| and exhaust intakes and venting. |
|
| *Check for blockages. |
|
| *Check for proper voltage to the stove |
|
| *Replace defective part and gasket. |
|
|
|
| 5. Exhaust System | *Check for blockage, ash build. |
|
| *Inspect vent cap and clean out tee. |
|
| *Too many elbows, to long of run, or change size |
|
| *Protect venting from extreme weather elements. |
Smoke or smoke smell | 1. Exhaust System | |
spillage. |
| manufactured. Ensure venting is gas tight. |
|
| *Inspect exhaust fan and gasket area, ensure a |
|
| tight fit |
|
| *Proper maintenance and cleaning. |
|
|
|
| 2. Over Feeding. Fuel over- | *Check air inlet damper for proper setting. |
| filling burn grate | *Adjust feed rate to lower level |
|
|
|
The stove keeps going | 1.Fresh unburned fuel or | *Check air inlet damper, may need more air. |
out. | powder like ash build up in | *Fine tune feed rate, to lower amount of fuel |
| the grate. | *Ensure good quality day fuel supply. |
|
| *Proper maintenance and cleaning. |
| 2.No fuel or ashes found in | *Adjust air inlet damper to reduce amount of air |
| The burn grate | to burn grate. Exhaust temperature to low and |
|
| temperature disk is turning off stove. |
|
| *Adjust control to increase fuel feed rate. |
The stove will not shut | 1.Control | *Press OFF touch pad, the stove will continue to |
off. |
| run for 30 minutes after the exhaust has cooled |
|
| properly |
|
| *Confirm mode of operation |
|
|
|
| 2.Wall Thermostat | *Ensure wall thermostat is turn down below the |
|
| room temperature.(Thermostat On/Off Mode) |
|
| *Unit will not shut off in the (Thermostat Low/ |
|
| High mode). You must press the OFF touch pad. |
Glow Boy Pellet & Biomass | www.glowboystoves.com | 38 |
|
| 38 |
|
|
|
