Dansons Group IGB, FGB manual Heating Specifications, Dimensions, Electrical Specifications

SPECIFICATIONS

HEATING SPECIFICATIONS

Approx. Heating capacity (sq. feet) *	800 – 2,000
Approx. Fuel burn rate per hour **	1.5 – 5 lbs
Hopper Capacity - Freestanding Step Top	90 lbs	Approx. Burn time at lowest setting	65 hrs
Hopper Capacity— Classic Insert / Built-in	40 lbs.	Approx. Burn time at lowest setting	27 hrs
Hopper Capacity - Bay View Freestanding	60 lbs	Approx. Burn time at lowest setting	48 hrs
Hopper Capacity – Bay View Insert / Built-in	40—60 lbs.	Approx. Burn time at lowest setting	27-48

¹ Heating capacity will vary depending on floor plan layout of your home, degree of insulation, and the outside temperature. Fuel size, quality, density and moisture level will also have an effect.

¹¹Pellet size may affect the actual rate of fuel feed and burn times. Fuel feed rates may vary by as much as 20%. Use PFI listed fuel for best results, pelletheat.org for further information.

DIMENSIONS

24”

30”

26”

25”

7” Exhaust

+

+ 17”

Air Inlet 8 1/4” 12 3/4”

Shroud 1”
12 1/4”	10 3/4”			26”
				24”
	Adjustable
	Hopper	19”			6 ½”
		-			Exhaust
		23”
				+
			3 ½”
				+	7 3/4”
	24”			Air Inlet	8 1/4”

Bay View Freestanding

Bay View Insert / Built-In

Product subject to Change without notice.

24”

32 ½”

24 3/4” 24”

6 1/2” Exhaust

+

	+	17 1/4”
Air Inlet	8 1/4”	12 3/4”

Shroud 1”
12 1/4”	10 3/4”	24 3/4”
		24”
			6 1/2”
	18 3/4”		Exhaust
	3 ½”	+
		+	7 3/4”
	24”	Air Inlet	8 1/4”

Step Top Freestanding

Classic Insert / Built-In

ELECTRICAL SPECIFICATIONS

Electrical Rating	=	115	Volts 60 HZ 2.0 Amps
Watts (operational)	=	175 (approximately)
Watts (optional igniter)	=	475	(approximately)

A voltage surge protector or ground fault outlet is required for this unit. The warranty on the circuit board will be voided if surge protection is not installed before operating this unit.

If power outages or disturbances are a concern, you may wish to purchase a gas powered generator, solar or battery back-up system. Ensure that it is a “Positive” sign wave and a minimum 1000 watts continual.

EPA COMPLIANCE

This heater is exempt from EPA Phase II requirements, but has been tested for emissions using EPA test methods by Warnock Hersey , US. Pellet appliances that are designed with the combustion air supply exceeding 35:1 (by ratio) are exempt from EPA regulations.

Glow Boy Pellet & Biomass www.glowboystoves.com 8