MOBILE HOME INSTALLATION
CAUTION: DO NOT INSTALL STOVE IN SLEEPING ROOM
THE STRUCTURAL INTEGRITY OF THE MANUFACTURED HOME FLOOR,
CEILING/ROOF MUST BE MAINTAINED!
Your PELPRO stove has been tested and listed for mobile home installation. It may be installed in a mobile home as a "Free Standing Stove", a "Hearth Stove", or as an "In Insert" installed in an existing wood or coal- burning fireplace or as an "Built
In addition to all previously detailed installation requirements, mobile home installations must meet the following requirements:
Permanently bolt your stove to the floor, (A). Figure 23, 24
Electrically ground your stove or the pedestal to the steel frame of the home. Use a number 8 gauge copper wire, (B) figure 24, or equivalent.
The stove must have a permanent outside air source with a ¼ inch screen over the inlet. Figure 23, (B,C, D)
For transportation all chimney / vent above the mobile home must be removed.
“PL” Vent must be 3” or 4” PL Vent and must extend a minimum or 36” above the roofline of the mobile home and must be installed using a UL/ULC listed ceiling fire stop (J), figure 23, and rain cap (L), figure 23.
INSTALL VENT AT CLEARANCES SPECIFIED BY THE VENT MANUFACTURER.
| A | Floor Pad |
L | B | Combustion Air Intake |
K | C | Fresh Air Duct |
D | Fresh Air Hood | |
| E | Stove Exhaust |
| F | Pipe Adapter |
| G | Clean Out Tee |
| H | Tee Support Bracket |
J | I | Pipe |
| J | Firestop Spacer / Ceiling Support |
| K | Roof Flashing / Storm Collar |
| L | Rain Cap |
I |
|
|
| H |
|
|
|
| G |
|
|
|
| HEARTH PAD |
| A | BOLT(S) |
| FLOOR |
| ||
|
|
|
| |
B | C D |
| FRAME |
|
| B | GROUND |
| |
A |
| WIRE |
| Figure 24 |
|
|
| ||
Figure 23 |
|
|
|
Note: When moving your Mobile Home, all exterior venting must be removed while Mobile Home is being relocated. Upon completion of relocation all venting must be reinstalled and securely fastened.
Canadian Comfort Industries V04 | 17 | PELPRO OWNERS MANUAL |
Copyright 2004 | www.pelprostoves.com | Dansons Group Inc. |