TeamPoS 3000 XL and XL2 | Installation |
Typical VGA Cabling
VGA (required)
pUSB (required)
Audio (optional)
Mounting Bracket
10.Attach the stand to the back of the LCD with the screws provided. Make sure that the tabs on the bottom hinge cover fit into the notches in the back of the LCD. To assure proper alignment of the LCD, attach screws “lightly” at first. Before tightening the screws make sure that the stand is slid up as far as it will go, then tighten screws.
VGA Configuration with Attached Stand
Mounting
Screws
Note: The Video (VGA) cable is routed so that it comes out the right side of the bracket rather than at the top. Where the DVI cable is used, it is routed so that it comes out the left side of the bracket.
D900000145 | Issue 3 |
