
TeamPoS 3000 XL and XL2 | Installation |
4.With the Keypad/MSR facing down, remove the back cover by pushing in on the latches at the bottom and long edge then lift off the back cover. (The MSR has one latch.)
Mounting Edge | Bottom Edge | |
Latch | ||
Latches | ||
|
5.With Keypad/MSR face down, slide it into the side of the LCD so that the guide pins slide into the slots. Make sure that the connector cable is not pinched between the Keypad/MSR and the LCD. Fasten with screws.
Guide Pins in
Slot
Anchoring
Screws
M3x0.5 panhead phillips SEMS 8mm
D900000145 | Issue 3 |