
TeamPoS 3000 XL and XL2 | Site Preparation |
4.5Preparing for Installation:
Before installing equipment, perform the following steps:
•Move all terminal components, accessories, and cables to the locations specified in your local site plan.
•Position the cables according to the site plan. Make sure you have the correct data cable at each terminal location.
•Place the optional equipment next to the terminal to which it will be connected.
•Remove the shipping tape from those components that have been taped.
4.6Determining Power Requirements
Electrical power to the equipment must comply with all local, state, and national wiring codes and meet the requirements described here. If you do not have qualified
Before installing the terminal, check the power lines for loads that could cause large variations in voltage. Electrical devices that use a great deal of power such as air conditioners, elevators, copying machines and large motors can cause large drops in voltage. When severe electrical interference occurs, installing radio frequency (RF) filters, or an isolation transformer, or both may be necessary. If voltage surges caused by lightning are likely to occur, install an arrester.
Caution: To prevent data loss, do not plug other equipment that can produce sudden surges (i.e., vacuum cleaners) into the same power circuit as the terminal.
D900000145 | Issue 3 |