Fujitsu 3000 XL manual Screws Disconnect operator Cable

TeamPoS 3000 XL and XL2 Maintenance

7.Pull the entire assembly out of the controller. Unscrew motherboard from chassis (2 screws) and disconnect the operating panel cable from the motherboard.

2 screws

Disconnect operator

cable

Note: Depending on your maintenance procedures, it may be necessary to remove the CPU, heat sink, memory, CD drive and/or mini-PCI card from the old motherboard and reinstall on the new motherboard. See appropriate sections of this chapter for removal and replacement instructions.

8.Insert the replacement board onto the chassis and secure with 2 screws.

9.Reconnect the operating panel cable. Reinstall any other optional hardware. See note above.

10.Make sure that the assembly rails line up with the rails in the chassis. Slide the motherboard assembly in with the release lever at 45° angle.

7-6 Issue 3 D900000145