TeamPoS 3000 XL and XL2 | Installation |
Caution: Ports designated as Port C on the backplane (24V PUSB) and Port 3 on the Combo board (24V RS232) do not meet UL limited power source (LPS) requirements. These ports are limited to only allowing 24V Retail POS RS232 or powered USB peripherals that do not exceed a rated current of 4 Amps and are provided with a Fire Enclosure, Rated Min.
Note: When Combo Board is installed, only one 24V port should be used for 24V printer. Port 3 and Port C cannot provide 24V power to 2 printers simultaneously.
1.Remove the back panel (See Section 5.1.2).
2.Disconnect the AC power cord from the controller.
3.Remove the front panel (See Section 5.1.1). The yellow LED light should be off (See Section 1.2).
4.Unseat the motherboard (See Section 5.2).
5.Remove the backplane assembly (See Section 5.9).
6.Remove top filler plate by first removing retainer clip by pulling on the black plug at the center of the filler plate then remove the 2 mounting screws. Retain screws and clip (See Section 5.10.2).
7.Invert combo card so that the ports face away from the backplane. Connect the three port cables to the following ports on the backplane: J13, J11, and J10. The ports are labeled on the backplane.
D900000145 | Issue 3 |
