TeamPoS 3000 XL and XL2 | Installation |
6.Place the first LCD face down on a clean dry surface. Remove the back cover by pressing in where indicated by symbol. Note the screws required to attach the LCD are taped to the inside of this cover.
Back of LCD | Back Cover |
Mounting Screws
Panhead, Phillips
M3x0.5 x 8mm
Press Here and Lift | A to B USB for opt. | Audio | LCD Power for opt. | Touch Panel | |
power brick | |||||
| MSR or Keypad MSR |
| Switch | ||
| DVI | pUSB | VGA |
|
Notches for lower hinge cover
7.Attach (lightly) the operator facing arm of the stand to the back of the LCD with the screws provided pushing the LCD as far towards the connectors as it will go. Make sure that the tabs on the bottom hinge cover of the stand fit into the slots in the back of the LCD. Finish tightening the screws so they are snug.
8.Place the customer facing LCD flat
D900000145 | Issue 3 |
