TeamPoS 3000 XL and XL2

Maintenance

Chapter 7 - Maintenance

Caution: Confirm that the external power source is 100-240 VAC before starting the operation. To prevent electrical shock, confirm that the AC cable is removed from the AC outlet anytime the covers are removed. Be sure to observe all ESD precautions and power OFF procedures.

7.1Periodic Maintenance

Only trained personnel must perform the following:

Vacuum all ventilation passageways on the control unit and peripherals. Ensure that these passageways are open and free of dust and other debris that could restrict airflow.

Check the Power Supply Unit fan for proper operation annually. See BIOS settings for typical fan speeds. If fan speed is approaching the low end, the fan should be replaced. Fan speeds can be found under the hardware monitoring section of the BIOS. Replace lead acid batteries every three years. If the model DT50III has the MICR option, check the function of, and clean the MICR after every 6000 checks.

7.1.1 Power ON and OFF Sequence

This section presents the general procedures for powering ON and powering OFF the TeamPoS 3000 control unit. The instructions in this section assume that the terminal, operating system and the application software have been installed. For any additional power-up procedures dictated by the retail application, refer to the manuals provided with the application software.

Caution: With the exception of USB peripherals, never disconnect or connect a peripheral while power is on its port. To avoid damage to the control unit and peripherals, when connecting and disconnecting RS232 peripherals from the Boards, turn power OFF with the ports OFF switch (see section 1.2), the TeamPoS 3000 power switch in the front of the unit or by disconnecting AC power.

D900000145

Issue 3

7-1

Page 134
Image 134
Fujitsu 3000 XL manual Periodic Maintenance