
TeamPoS 3000 XL and XL2 | Installation |
5.13. Standard Bracket Locations
For stacked configurations, keyboard, printer, filler and operator display brackets are available. The brackets attach to the top of the control unit and restrain the peripherals from sliding. When installing the peripheral brackets, install each bracket using the two screws that have been provided with the bracket. For most stacked installations keyboard, printer, filler and display brackets will be required.
Note: See bracket options in Chapter 11 for part numbers. When installing, do not over- tighten the screws.
Installing the brackets requires placing the bracket on the appropriate screw holes on the top of the chassis and securing with the two screws provided for each bracket. To prevent dust and moisture penetration, apply a
The following shows peripheral bracket locations for the standard control unit. If an LCD is installed on a standard unit with a DT50 Series printer, then central filler occupies the space between them. When a CT10 printer is used, an additional
Stacked LCD Brackets 4 Screws, Pan head phillips,
SEMS, nickel plated M3x0.5 x 8mm
Central Filler Bracket
2 Screws, Flat head,
DT50 Series Bracket
2 Screws, Pan head, Phillips, SEMS, nickel plated M3x0.5 x 10mm
Keyboard Bracket
2 Screws, Flat head,
Standard Unit showing
Bracket Configuration for DT50 Series
D900000145 | Issue 3 |