Fujitsu 3000 XL manual Combo Board with COM Board XL Motherboard only

TeamPoS 3000 XL and XL2 Installation

5.11.4Combo Board with COM Board (XL Motherboard only)

(XL2 Motherboard does not support the COM board)

Caution: Ports designated as Port C on the backplane (24V PUSB) and Port 3 on the Combo board (24V RS232) do not meet UL limited power source (LPS) requirements. These ports are limited to only allowing 24V Retail POS RS232 or powered USB peripherals that do not exceed a rated current of 4 Amps and are provided with a Fire Enclosure, Rated Min. V-1 or Metal. Peripherals intended to be connected via - Jacketed Cable for external use rated 30 V, max 3.05m long, marked VW-1 or FT-1.

Note: When Combo Board is installed, only one 24V port should be used for 24V printer. Port 3 and Port C cannot provide 24V power to 2 printers simultaneously.

1.Remove the back panel. (See Section 5.1.2).

2.Disconnect the AC power cord from the controller.

3.Remove the front panel (See Section 5.1.1). The yellow LED should be off (See Section 1.2).

4.Unseat the motherboard (See Section 5.2).

5.Remove the backplane assembly (See Section 5.9).

D900000145 Issue 3 5-33