Connections
Surround back speakers
Surround back speakers are required when a full
Speakers should be placed on a rear wall, behind the lis- tening position.
The center of the speaker should face into the room.
Subwoofer
We recommend using a subwoofer to have maximum bass effect. Subwoofer bears only low frequency range so you can place it any where in the room.
HEIGHT OF THE SPEAKER UNITS
Front left and right speakers, and a center speaker
Align the tweeters and
Surround left and right speakers, and surround back speaker
Place the surround left, right and surround back speakers higher than your ears by about 70cm
Also place the speakers at the same height, as best as pos- sible.
70cm
1m
Note:
•Use
CONNECTING SPEAKER WIRE
1.Strip away approx. 10 mm of wire insulation.
2.Twist the bared wire ends tight, to prevent short circuits.
3.Loosen the knob by turning it counterclockwise.
4.Insert the bare part of the wire into the hole in side of each terminal.
5.Tighten the knob by turning it clockwise to secure the wire.
1.2.
10mm
3.4. 
5.
Caution:
•Be sure to use speakers with the specified impedance as shown on the rear panel of this unit.
•To prevent damage to circuitry, do not let the bare speak- er wires touch each other and do not let them touch any metal part of this unit.
•Do not touch the speaker terminals when the power is on. It may cause you to receive an electric shocks.
•Do not connect more than one speaker cable to one speaker terminal. Doing so may damage this unit.
Note:
•Be sure to connect the positive and negative cables for the speaker properly. If they are miss connected, the sig- nal phase will be reversed and the signal quality will be corrupted.
CONNECTING A SUBWOOFER
Use the PRE OUT SUBWOOFER jack to connect a powered subwoofer (power amplifier built in ).
If your subwoofer is a passive type (power amplifier is not built in), connect a monaural power amplifier to the PRE OUT SUBWOOFER jack and connect the subwoofer to the amplifier.
- 7 -
