Datalogic Scanning 1000I manual Connecting the Scanner, An approved A/C Adapter as shown in . For

Getting Started

Connecting the Scanner

The scanner kit you ordered to match your interface should provide a compatible cable for your installation. Use the appropriate instructions below to connect the scanner to the terminal, PC or other host device.

Upon completing the connection via the appropriate interface instructions below, proceed to the Interface Related Features section of this manual and scan the bar code to select the correct interface type.

RS-232 Serial Connection — Turn off power to the terminal/PC and connect the scanner to the terminal/PC serial port via the RS-232 cable as shown in Figure 1. If the terminal will not support POT (Power Off the Terminal) to supply scanner power, use the approved power supply (AC Adapter). Plug the AC Adapter barrel connector into the socket on the RS-232 cable con- nector and the AC Adapter plug into a standard power outlet.

Figure 1. RS-232 Serial or USB Connection using A/C Adapter

Connect Here

I/F Cable	To Host/Terminal	For 220-230 VAC
		adapters, the
		cord must be
		facing down as
		shown in the
		illustration. If
		installed upwards,
	A/C Adapter	it will pose an
	(if needed)	undue strain on the
		socket outlet.

USB Connection — Connect the scanner to a USB port on the terminal/PC using the correct USB cable for the interface type you ordered. Reference Figure 1 and Figure 2.

	USB installations may require a power connection via
	an approved A/C Adapter as shown in Figure 1. For
	example, this would be the case if the scanner is con-
NOTE	nected along with a number of other devices to a non-
	powered USB hub.

Figure 2. Other Connection Types
				S		B
	U					K
						e
						y
or...						W b
			d			o			d
						g	a
						e
	n					d	e	r
					or...
	W
	a
or...		M
	IB
1-2									Magellan® 1000i