Datalogic Scanning 6000 manual Contents

Contents
Introduction ------------------------------------------------------------------------	1
Understanding the Basics	1
Integrating Peripherals With Host Systems	1
Changing Interfaces	2
Customizing Your Scanner Operation	4
Programming Overview	4
What Is Programming Mode?	5
How To Program Using Bar Codes	5
The Programming Session	6
Scanner Response When In Programming Mode	6
If You Make a Mistake	7
Return to Factory Settings	7
Where To Go From Here	8
IBM 4683/84 • 4693/94 Port 5B Interface Selection	9
IBM 4683/84 • 4693/94 Port 9A, 9B, 9C, 9E I/F Selection	10
IBM 4682/92 Port E Interface Selection	11
Datalogic OCIA1 Interface Selection	12
NCR OCIA Eight Bit (short format) Interface Selection	12
NCR OCIA Nine Bit (long format) Interface Selection	12
SNI OCIA Interface Selection	12
OCIA Options	13
Wand Emulation Interface Selection	14
RS-232 Interface Selection	16
SNI RS-232 Interface Selection	16
Hardware Control	19
Software Control	20
RS-232 ACK/NAK Options (QuickScan 6000 Plus ONLY)	21
PC Keyboard Wedge Interface Selection	24
PC Keyboard Wedge Interface Selection—continued	25
PC Keyboard Wedge –
Connect to a Laptop/No Keyboard Attached	26
Caps Lock (QuickScan 6000 Plus ONLY)	27
Country Mode (QuickScan 6000 Plus ONLY)	28
Intercharacter Delay	30
Label Transmit Format Configuration Items	32
(RS-232 and Keyboard Wedge Interfaces Only)	32
Prefix & Suffix	32
Non-Symbology Specific Items	34

Programming Guide