C-BOX 200 DATALOGIC
10 - Installation
2.4.3 Chassis Grounding Jumper Settings
The scanner chassis grounding method can be selected by positioning a
jumper (see Figure 2.9). In this way the scanner chassis can be connected to
earth ground (only if pins 7 or 8 are connected to a good earth ground) or to
the power supply ground signal. The scanner chassis can also be left floating
but, in this case, the jumper must be removed.
to EARTH
GROUND
(default)
to GND floating
Figure 2.9 – Chassis grounding
The C-BOX 200 is now installed which completes the electrical connections
for your scanning system.