Step 4: Inspect again with SensorScope
Inspect your sensor with the SensorScope to make sure all the large debris has been removed.
Step 5: Apply SensorSolution and wipe with SensorWand Remove one SensorWand from its packaging. Moisten one end of the wand with two drops of SensorSolution.
Caution: Do not use more than two drops of SensorSolution. Using more than two drops of SensorSolution may cause damage to your camera and its sensor. Two drops will effectively break the bond that holds tougher debris such as organics and fibers to the surface of your digital SLR sensor and filter. Don’t touch the SensorWand tip with your fingers. Oils may contaminate the SensorWand and your sensor surface. Because SensorSolution is quick drying, we recommend that you do not moisten the SensorWand until you are ready to start cleaning your sensor.
Once you have moistened the SensorWand (Side A) with two drops of SensorSolution, place the wet end on the left side of your sensor. Tilt the SensorWand as shown and gently wipe your sensor from left to right. Then, tilt SensorWand back as shown and begin a second wipe with the same moist end (Side A) from right to left.
Wipe Sensor from left to right using side A
B
A
Wipe Sensor from right to left using side A
B
A
Caution: Do not apply too much pressure. You may damage your sensor permanently if too much pressure is applied. It is best to start with light pressure and increase
pressure as needed.
10
