9.Connect the power and data cables to the back of the drives.
10.Replace the computer cover.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
11.Connect your computer and devices to electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.
Adding a Floppy Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in your Owner's Manual or Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.
1.Follow the procedures in "Before You Begin."
2.Release and remove the front panel.
3.Press in the two insert tabs, and then push out the
4.Connect the
NOTICE: Match the colored strip on the cable with pin 1 on the drive (pin 1 is marked as "1").
5.Connect the data cable to the back of the drive and to the floppy drive connector on the system board.
6.Position the top of the floppy drive bracket so that it is completely flush with the bottom of the upper drive bay, and then slide the floppy drive bracket
