w w w . d e l l . c o m / s u p p l i e s s u p p o r t . d e l l . c o m
Replacing the Fuser and Separator Roller
To avoid burns, do not replace the fuser immediately after printing, as the fuser gets very hot during this process.
CAUTION: To avoid burns, never touch the fuser until at least 30 minutes after you have turned off the printer.
CAUTION: Before performing any of the following procedures, read and follow the "CAUTION: SAFETY INSTRUCTIONS" on page 9.
Dell fuser are available only through Dell. You can order more online at http://www.dell.com/supplies or by phone. To order by phone, see "Order Printer Supplies" on page 2.
Dell recommends Dell fuser for your printer. Dell does not provide warranty coverage for problems caused by using accessories, parts, or components not supplied by Dell.
Removing the Used Fuser
NOTE: Remove any print jobs from the center output tray, and close the multipurpose feeder cover before opening the outer front cover.
1.Turn off the printer and wait for 30 minutes.
2.Push the side button and open the outer front cover.
50
