Removing and Installing Parts 85
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into
the computer.
7
Connect your computer and devices to electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software
required for drive operation.
Adding a Second Hard Drive CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet
before removing the cover.
NOTICE: To avoid damage to the drive, do not set it on a hard surface. Instead, set the drive on a
surface, such as a foam pad, that will sufficiently cushion it.
1
Check the documentation for the drive to verify that it is configured for your computer.
2
Follow the procedures in "Before You Begin" on page 53.
3
Press in on the blue release tabs on each side of the hard drive bracket and slide it up and out
of the computer.
4
Snap the bracket to the hard drive.
5
Gently slide the new drive (second hard drive) into place until you feel a click or feel the drive
securely installed.
6
Connect a power cable to the drive.
7
Connect the data cable to the drive and to the system board (see page62).
release tabs (2)
second hard drive
in lower bay
hard drive bay
primary hard drive
in upper bay