Wireless network setup

Canceling the connection process

To cancel the wireless network connection when the machine is connecting to

the wireless network, press and release the (power/cancel) button on the control panel. You need to wait 2 minutes to re-connect to the wireless

network.

Disconnecting from a network

To disconnect the wireless network connection, press the (WPS) button on the control panel for more than two seconds.

When the Wi-Fi network is in idle mode: The machine is immediately disconnected from the wireless network and the WPS LED turns off.

When the Wi-Fi network is being used: While the machine waits until the current job is finished, the light blinks fast on the WPS LED. Then, the wireless network connection is automatically disconnected and the WPS LED turns off.

9

Setup using Windows

Access point via USB cable in Windows

Items to prepare

-Access point

-Network-connected computer

-Software CD that was provided with your machine

-The machine installed with a wireless network interface

-USB cable

1Check whether the USB cable is connected to the machine.

2Turn on your computer, access point, and machine.

If the “Found New Hardware Wizard” appears during the installation procedure, click Cancel to close the window.

2. Using a Network-Connected Machine (B1160w only) 87

Page 87
Image 87
Dell B1160 Canceling the connection process, Disconnecting from a network, Access point via USB cable in Windows, Network