Dell C6105 RAID Battery (Optional)

Installing System Components | 91

7 Replace the system-board assembly. See “Installing a System-Board

Assembly” on page 69.

8 Reconnect the system to the electrical outlet and turn the system on,

including any attached peripherals.

9 Enter the System Setup program to confirm that the batte ry is

operating properly. See “Using the System Setup Program” on page 30.

10 Enter the correct time and date in the System Setup program’s Time

and Date fields.

11 Exit the System Setup program.

RAID Battery (Optional)

CAUTION: Many repairs may only be done by a cert ified service technician. You

should only perform troubleshooting and s imple repairs as authorized in your

product documentation, or as directed by the o nline or telephone service and

support team. Damage due to servicing that is n ot authorized by Dell is not

covered by your warranty. Read and follow the safet y instructions that came with

the product.

NOTE:

The information in this section applies only to systems wit h the optional

RAID controller card.

1 Turn off the system, including any attached peripherals, and

disconnect the system from the electrical outlet.

2 Remove the system-board assembly. See “Removing a System-Board

Assembly” on page 68.

3 To disconnect the RAID battery cable from the connector on the

PERC card, press the tab on the RAID battery cable connector, and

gently pull the cable connector out of the connector on the PERC card.

4 Press the RAID battery latch and lift the RAID battery to releas e it

from the RAID battery carrier. See Figure 3-17.