Dell CPt V/CPt S Series, CPx H/CPx J Series

20 Dell Latitude CPt V/CPt S Series and CPx H/C Px J Series Service Manual

 

(%)%%!

"



$

1. Remove the main battery and secondary battery (if present).

2. Remove the keyboard.

3. Close the display and remove the three 4-mm screws, labeled with a

“circle D,” from the back of the computer (see Figure 13).

4. Open the display and disconnect the LCD flex cable from the connector on

the system board by pulling the connector straight up.

5. Lift the display assembly from the bottom case assembly. Pry the hinge

cover loose at the seam from the snap tabs on the bottom assembly (see

Figure 13).

NOTE: Always remove and replace the LCD panel as a complete assembly.

4-mm screws (3)

LCD flex cable

display assembly

bottom case assembly

hinge cover

M2.5x4

snap tab