Battery
Replacing the Battery
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
A
If you have to repeatedly reset time and date information after turning on the computer, replace the battery.
CAUTION: A new battery can explode if it is incorrectly installed. Replace the battery only with the same or equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions.
To replace the battery:
1.Record all the screens in system setup so that you can restore the correct settings in step 8.
2.Follow the procedures in "Before you Begin."
3.Locate the battery socket.
NOTICE: If you pry the battery out of its socket with a blunt object, be careful not to touch the system board with the object. Ensure that the object is inserted between the battery and the socket before you attempt to pry out the battery. Otherwise, you may damage the system board by prying off the socket or by breaking circuit traces on the system board.
4.Remove the battery by carefully prying it out of its socket with your fingers or with a blunt, nonconducting object such as a plastic screwdriver.
5.Insert the new battery into the socket with the side labeled "+" facing up, and snap the battery into place.
1battery
2battery socket
6.Replace the computer cover.
NOTICE: To connect a network cable, first plug the cable into the network device and then plug the cable into the computer.
7.Connect your computer and devices to electrical outlets, and turn them on.
8.Enter system setup and restore the settings you recorded in step 1.
9.Properly dispose of the old battery. See the Product Information Guide for battery disposal information.
