About the SCv2000/SCv2020 Storage System

Item	Control/Feature	Icon	Description

3	MGMT port	—	10 Mbps, 100 Mbps, or 1 Gbps Ethernet port used for storage
			system management and access to the BMC
			NOTE: To use the MGMT port as an iSCSI port for
			replication to another Storage Center, a Flex Port license
			and replication license are required. To use the MGMT port
			as a front-end connection to host servers, a Flex Port
			license is required.
4	REPL port	—	10 Mbps, 100 Mbps, or 1 Gbps Ethernet/iSCSI port used for
			replication to another Storage Center
			NOTE: To use the RELP port as a front-end connection to
			host servers, a Flex Port license is required.
5	SAS activity indicators	—	• Off: Port is off
			• Steady green: Port is on, but without activity
			• Blinking green: Port is on and there is activity
6	Storage controller		On: Storage controller completed POST
	module status

7Recessed power off button

8Storage controller module fault

Powers down the storage controller if held for more than five seconds

•Off: No faults

•Steady amber: Firmware has detected an error

•Blinking amber:Storage controller is performing POST

9Recessed reset button

10Identification LED

11USB port

12Diagnostic LEDs (8)

13Serial port (3.5 mm mini jack)

14Four or two iSCSI ports with two LEDs per port

15Mini-SAS port B

16Mini-SAS port A

Reboots the storage controller forcing it to restart at the POST process

• Off: Identification disabled

•Blinking blue (for 15 sec.): Identification is enabled

•Blinking blue (continuously): Storage controller shut down to the Advanced Configuration and Power Interface (ACPI) S5 state

Not for customer use on SCv2000/SCv2020 Storage Systems.

—• Green LEDs 0–3: Low byte hex POST code

• Green LEDs 4–7: High byte hex POST code

Not for customer use.

—• Off: No power

•Steady Amber: Link

•Blinking Green: Activity

Back-end expansion port B

Back-end expansion port A

Dell E09J, E10J owner manual About the SCv2000/SCv2020 Storage System