Item | Control/Feature | Icon | Description |
|
|
|
|
|
|
| NOTE: To use the MGMT port as an iSCSI port for |
|
|
| replication to another Storage Center, a Flex Port license |
|
|
| and replication license are required. To use the MGMT port |
|
|
| as a |
|
|
| license is required. |
4 | REPL port | — | 10 Mbps, 100 Mbps, or 1 Gbps Ethernet/iSCSI port used for |
|
|
| replication to another Storage Center (requires a replication |
|
|
| license) |
|
|
| NOTE: To use the RELP port as a |
|
|
| host servers, a Flex Port license is required. |
5 | SAS activity indicators | — | • Off: Port is off |
|
|
| • Steady green: Port is on, but without activity |
|
|
| • Blinking green: Port is on and there is activity |
6 | Storage controller |
| On: Storage controller completed POST |
| module status |
|
|
7Recessed power off button
8Storage controller module fault
Powers down the storage controller if held for more than five seconds
•Off: No faults
•Steady amber: Firmware has detected an error
•Blinking amber:Storage controller is performing POST
9 | Recessed reset button |
| Reboots the storage controller forcing it to restart at the POST |
|
|
| process |
10 | Identification LED |
| • Off: Identification disabled |
|
|
| • Blinking blue (for 15 sec.): Identification is enabled |
|
|
| • Blinking blue (continuously): Storage controller shut down |
|
|
| to the Advanced Configuration and Power Interface (ACPI) |
|
|
| S5 state |
11 | USB port |
|
|
12 | Diagnostic LEDs (8) | — | • Green LEDs |
|
|
| • Green LEDs |
13 | Serial port (3.5 mm mini |
| Not for customer use. |
| jack) |
|
|
14Four or two Fibre Channel ports with three LEDs per port
15
—• All off: No power
•All on: Booting up
•Blinking amber: 2 Gbps activity
•Blinking green: 4 Gbps activity
•Blinking yellow: 8 Gbps activity
•Blinking amber and yellow: Beacon
•All blinking (simultaneous): Firmware initialized
•All blinking (alternating): Firmware fault
12 | About the SCv2080 Storage System |
