Dell E11J001 owner manual Item Control/Feature

Item Control/Feature Icon Description

				NOTE: To use the RELP port as a front-end connection to
				host servers, a Flex Port license is required.
5	SAS activity indicators	—	•	Off: Port is off
			• Steady green: Port is on, but without activity
			•	Blinking green: Port is on and there is activity

6Storage controller module status

7Recessed power off button

8Storage controller module fault

On: Storage controller completed POST

Powers down the storage controller if held for more than five seconds

•Off: No faults

•Steady amber: Firmware has detected an error

•Blinking amber:Storage controller is performing POST

9	Recessed reset button		Reboots the storage controller forcing it to restart at the POST
			process
10	Identification LED		•	Off: Identification disabled
			• Blinking blue (for 15 sec.): Identification is enabled
			• Blinking blue (continuously): Storage controller shut down
				to the Advanced Configuration and Power Interface (ACPI)
				S5 state
11	USB port
12	Diagnostic LEDs (8)	—	• Green LEDs 0–3: Low byte hex POST code
			• Green LEDs 4–7: High byte hex POST code
13	Serial port (3.5 mm mini		Not for customer use.
	jack)
14	Four or two iSCSI ports	—	•	Off: No power
	with two LEDs per port		• Steady Amber: Link
			• Blinking Green: Activity
15	Mini-SAS port B		Back-end expansion port B
16	Mini-SAS port A		Back-end expansion port A

14 About the SCv2080 Storage System