Removing and Installing Parts: Dell Dimension E520 Service Manual
1 | alignment bar | 2 | fully seated card | 3 | not fully seated card | |
4 | alignment guide | 5 | bracket within slot | 6 | bracket caught outside of slot | |
10. | Ensure that: |
|
|
|
| |
|
| The tops of all cards and filler brackets are flush with the alignment bar. | ||||
|
| The notch in the top of the card or filler bracket fits around the alignment guide. | ||||
11. | If previously removed, snap the card retention mechanism into place, securing the x16 PCI card. | |||||
1 card retention door | 2 card retention mechanism | 3 release tabs (2) |
NOTICE: Do not route card cables over or behind the cards. Cables routed over the cards can prevent the computer cover from closing properly or cause damage to the equipment.
NOTICE: To connect a network cable, first plug the cable into the network device and then plug it into the computer.
12. Replace the computer cover (see Replacing the Computer Cover).
file:///T/htdocs/systems/dimE520/en/SM_EN/parts.htm[10/16/2012 1:05:24 PM]
