Contents
Main
Notes, Cautions, and Warnings
followed.
Contents
7 Installing RPMs, Line Cards, and SFMs
8 RPM Ports and Cables
9 Powering Up
10 Removing and Replacing Parts
11 Using a Flash Memory Card
A System Boot
B Alarms
C System Specifications
D Technical Support
Page
About This Guide
Information Symbols and Warnings
Related Publications
Site Preparation
Site Selection
Equipment Rack and Cabinet Requirements
Power Requirements
Storage Requirements
The E600i System
Operating Overview
Page
E600i System Installation Process
Page
Installing the Chassis
Unpacking the E600i System
Installing the Equipment Rack Shelf Bar
Standard Front Chassis Rack Mounting
Installing the Chassis into an Equipment Cabinet
Page
Installing the Fan Tray
Page
Power Supply
AC Power Supply Units
Page
Remove the AC Power Supply
To remove an AC power supply unit:
Cord Retainer
Power Cord
Thumb Screw
DC Power Entry Modules
Page
To remove a PEM:
Page
Installing RPMs, Line Cards, and SFMs
Unpacking
Line Cards and RPMs
Preparing and Installing the RPMs and Line Cards
To install line cards and RPMs:
RPM Label and LEDs
Line Card LEDs
You must install SFMs starting on the left (slots 3 or 0) moving to the right (slots 2 or 4).
Installing Switch Fabric Modules (SFMs)
Page
SFM Front Panel and LEDs Table 7-2
defines the SFM front panel and LED displays.
Page
RPM Ports and Cables
RPM Ports
Cable and Adapter Pin Assignments
Page
Accessing the 10/100 Ethernet Management Port
Powering Up
Preparation
Supplying Power
Booting to the CLI Prompt
Removing and Replacing Parts
Removing and Replacing the Fan Tray
Removing and Replacing Power Modules
Page
To remove a PEM:
Removing and Replacing RPMs, Line Cards, or SFMs
for more details. To remove and replace RPMs and line cards:
To remove and install an SFM:
Removing and Replacing the Air Filter
Page
Page
Using a Flash Memory Card
External Flash Memory Card Overview
Formatting an External Flash Card
Copying Files to the External Flash
Displaying Files Stored on the External Flash
Page
Page
A
System Boot
The E600i System Boot Process
Booting from the BOOT_USER Prompt
To configure the chassis from the BOOT_USER prompt:
Page
Page
Page
Page
B
Alarms
AC Power Supplies and Alarms
SFMs and Alarms
Page
Page
C
System Specifications
Chassis Physical Design
Environmental
AC Power Supply Unit Requirements
DC Power Entry Module Requirement
SFM and RPM Power Requirements Agency Compliance
The E600i is designed to comply with the following safety and agency requirements.
which case, the user may be required to take adequate measures.
SFM 60W (210 BTU/hour) RPM 150W (510 BTU/hour)
Page
Page
Page
D
Technical Support
The iSupport Website
Contacting the Technical Assistance Center
, below, for more.
Contacting the Technical Assistance Center
Requesting a Hardware Replacement
To request replacement hardware, follow these steps:
