Dell M610 manual Icon Description

Dell™ PowerEdge™ M610 Technical Guidebook

FEATURE

icon

description

		Off – Power is not available to the blade, the blade is in standby
		mode, the blade is not turned on, or the blade is installed
		incorrectly. For detailed information on installing a blade, see
Blade Power		"Installing a Blade."
Indicator		Green increasing from low brightness to full brightness – Blade
		power on request is pending.
		Green on – The blade is turned on.
		Off – The blade power is off.
		Blue – Normal operating state.
Blade Status/		Blue Blinking – The blade is being remotely identified via the CMC.
Identification
Indicator		Amber Blinking – Blade has either detected an internal error, or
		the installed mezzanine card(s) does not match the I/O modules
		installed in the M1000e enclosure. Check the CMC for an I/O
		configuration error message and correct the error.
		Turns blade power off and on.
		• If you turn off the blade using the power button and the blade
		is running an ACPI-compliant operating system, the blade can
		perform an orderly shutdown before the power is turned off.
Blade Power		• If the blade is not running an ACPI-compliant operating system,
	N/A	power is turned off immediately after the power button is pressed.
Button
		• Press and hold the button to turn off the blade immediately.
		The blade power button is enabled by default by the System Setup
		program. (If the power button option is disabled, you can only use
		the power button to turn on the blade. The blade can then only be
		shut down using system management software.)
USB Connector		Connects external USB 2.0 devices to the blade.

7