Configuring IP Multicast 719
PIM-SM Interface Configuration
Use the PIM-SM Interface Configuration
page to configure PIM-SM for an interface. PIM-SM must be
enabled on the PIM-SM Global Configuration
page for this interface configuration page to display.
To display the page, click Multicast > PIM-SM > Interface Configuration in the tree view.
Figure 12-48. PIM-SM Interface Configuration
The PIM-SM Interface Configuration page contains the following fields:
•
Interface
— Select the interface for which data is to be displayed or configured. At least one routing
interface must exist in order to display or configure data.
•
Mode
— Select Enable or Disable from the drop-down menu to set the administrative status of PIM-
SM on this interface. The default is Disable.
•
Hello Interval (secs)
— Enter the time in seconds between th e transmission of which PIM Hello
messages on this interface. The valid values are from 10 to 3600 secs. The default value is 30.
•
CBSR Preference
— Enter the preference value for the local interface as a candidate bootstrap router.
The value of -1 is used to indicate that the local interface is not a candidate BSR interface. The valid
values are from -1 to 255. The default value is 0.