62 Appendix—Manual Configuration of iSCSI
c
Verify that the following time-out value is set to 30:
node.session.timeo.replacement_timeout = 30
d
Save and close the
/etc/iscsi/iscsid.conf
file.
5
From the console, restart the iSCSI service with the following command:
service iscsi start
6
Verify that the iSCSI service is running during boot using the following
command from the console:
chkconfig iscsi on
7
To display the available iSCSI targets at the specified IP address, use the
following command:
iscsiadm –m discovery –t st -p
<IP_address_of_iSCSI_port>
8
After target discovery, use the following command to manually log in:
iscsiadm -m node –l
This log in is performed automatically at startup if automatic startup is
enabled.
9
Manually log out of the session using the following command:
iscsiadm -m node -T <initiator_username> -p
<target_ip> -u
This step specifies which host servers access virtual disks on the storage array.
You should perform this step:
• Before mapping virtual disks to host servers
• Any time you connect new host servers to the storage array
1
Launch MDSM.
2
Navigate to the AMW and click
Manually define hosts
.
3
At
Enter host name
, enter the host server for virtual disk mapping.
This can be an informal name, not necessarily a name used to identify the
host server to the network.
4
Select a method for adding the host port identifier.
book.book Page 62 Sunday, September 11, 2011 10:24 PM