Adding and Replacing Parts 181

Replacing the Card

1
Replace the card at an angle to slide it under the securing tabs in the card
compartment.
2
Connect the cable to the card.
Coin-Cell Battery
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface (such as a
connector on the back of the computer).
NOTICE: To help prevent damage to the system board, you must remove the battery
from the battery bay before you begin working inside the computer.

Removing the Coin-Cell Battery

1
Follow the procedures in "Before You Begin" on page 153.
2
Turn the computer over.
3
Loosen the captive screw on the memory module/coin-cell battery cover
(see "Bottom View" on page32), and remove the cover.
4
Disconnect the coin-cell battery cable from the system board.
5
Slide the battery out of the mylar sleeve.
1 coin-cell battery 2 mylar sleeve 3 battery cable connector
2
1
3