Dell R420, E18S001 owner manual IDRAC Ports Card Optional, Installing Expansion-Card Risers 1

Figure 33. Removing and Installing the Expansion-Card Riser 2
1.	chassis intrusion switch	4.	expansion-card riser 2 connector
2.	expansion-card riser touch points	5.	riser guides (2)

3.expansion-card riser 2

5.Replace the expansion-card riser.

6.Close the system.

7.Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

Installing Expansion-Card Risers 1 And 2

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1.If applicable, reinstall the expansion card(s) into the expansion-card riser.

2.Align the expansion-card riser with the connector and the riser guides on the system board.

3.Lower the expansion-card riser into place until the expansion-card riser connector is fully seated in the connector.

4.Close the system.

5.Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

6.Install any device drivers required for the card as described in the documentation for the card.

iDRAC Ports Card (Optional)

The iDRAC Ports card supports:

•one 1GbE Ethernet port

•SD vFlash card

70