Dell S300wi manual Using Your Projector

NOTE:

1.When you want to create 3D experience, you will need a few other components including:

a PC/NB with a 120 Hz signal output quad buffered graphics card. b "Active" 3D glasses with DLP Link™.

c 3D content. See "Note 4".

d 3D Player. (Example: Stereoscopic Player...)

2.Enable the 3D function when it satisfies any of the below-mentioned conditions:

a PC/NB with graphics card, capable of outputting at 120Hz signal via VGA or HDMI cable.

b inputs a suite of 3D content via Video and S-Video.

3.When projector detects either of the inputs (mentioned above), the enable 3D display on "SETUP" -> "3D Display" OSD works.

4.Current 3D support time is as indicated: a VGA/HDMI 1280 x 720 120 Hz

b Composite/S-Video 60 Hz c Component 480i

5.The recommended VGA signal for NB is Single mode output (Dual mode is not recommended)

3D Sync Invert—If you see a discrete or overlapping image while wearing DLP 3D goggles, you may need to execute 'Invert' to get best match of left/right image sequence to get the correct image. (For DLP 3D goggles)

STANDBY VGA OUTPUT—Select On or Off the VGA output function at projector standby status. Default is Off.

WIRELESS / NETWORK—Select On to activate wireless / network function. Press to configure the Wireless / Network settings.

Using Your Projector

55