USB Display Driver Installation
In order to use your USB Display, you need to complete the steps below:
1Enable Wireless / Network connection on the projector. See "WIRELESS / NETWORK" on page 56.
NOTE: When you start wireless, please wait about 50 seconds to reboot the Wireless / Network.
2Connecting the USB cable to your projector and computer. See "Connecting a Computer Using an USB Display" on page 17.
3On INPUT SELECT menu, select Multiple Display and then select USB Display on
4The first time a user uses this mode, the projector automatically prompts for the following drivers to be installed. Start the installation manually by clicking "dousb_install.Cab" on CD Drive.
NOTE: If pop up "AutoPlay" installation window, please close it.
5System will start to install the Remote NDIS driver on your computer at first time.
NOTE:
•If the warning message appears, please ignore and allow for installation.
•You may require administrator level access to install the software.
6Start to display the computer screen through USB cable.
NOTE: When the computer resumes from standby or hibernation mode, the display over USB can also be resumed automatically. If it fails to resume automatically, you have to unplug and plug the USB cable again.
Using Your Projector
77
