Dell T2310 manual Installing the Processor

Processor

CAUTION: Before you perform this procedure, follow the safety instructions on page 9.

Installing the Processor

NOTE: It is recommended that only a technically knowledgeable person perform this procedure.

CAUTION: The processor can get very hot during normal operation. Ensure that the processor has had sufficient time to cool before you touch it.

1Follow the instructions in "Before You Begin" on page 68.

2Open the computer cover (see page 70).

3Remove the processor airflow shroud (see page 91).

If you are replacing a processor, follow steps 4, 5, and 6 in "Removing the Processor" on page 95.

NOTICE: You must position the processor correctly in the socket to avoid permanent damage to the processor and the computer.

4If the release lever is not extended to the release position, move it to that position.

5Align pin-1 (the imprinted corner) of the processor and pin-1 of the socket.

NOTICE: Processor pins are delicate. To avoid damage, ensure that the processor aligns properly with the socket, and do not use excessive force when you install the processor.

6Carefully set the processor in the socket and press it down lightly to seat it.

7Rotate the release lever back toward the system board until it snaps into place, securing the processor.

Removing and Installing Parts

93