Dell T8243, DHP manual Replacing the External Modem Connector

w w w . d e l l . c o m s u p p o r t . d e l l . c o m

3Remove the existing modem:

a Disconnect the modem cable from the modem.

b Use a small Phillips screwdriver to remove the two screws securing the modem to the system board, and set the screws aside.

c Pull straight up on the attached pull-tab to lift the modem out of its connector on the system board.

NOTICE: The connectors are keyed to ensure correct insertion. If you feel resistance, check the connectors and realign the card.

4Install the new modem:

a Align the modem with the screw holes and press the modem into the connector on the system board.

b Use a Phillips screwdriver to replace and tighten the two screws that secure the modem to the system board.

c Connect the modem cable to the modem.

5Replace the computer cover (see page 91).

Replacing the External Modem Connector

1Follow the procedures in "Before You Begin" on page 53.

2Remove the computer cover (see page 59).

3Remove the modem cable from the modem.

4Remove the external modem connector:

a Remove the screw that secures the external modem connector.

b Slide the external modem connector away from the slot that holds the modem connector in place.

c Lift the modem cable and connector from the computer.

88

Removing and Installing Parts