Dell YT465 manual Hinge Cover, 118

Hinge Cover

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on the back of the computer).

NOTICE: The hinge cover is fragile and can be damaged if extreme force is used. Be careful when removing the hinge cover.

1Follow the procedures in "Before You Begin" on page 115.

2Turn the computer top-side up, and then open the display all the way (180 degrees) so that the display rests on your work surface.

NOTICE: To avoid damaging the hinge cover, do not lift the cover on both sides simultaneously. Removing the hinge cover in a different way than described may cause the plastic to break.

1

2

3

1 hinge cover 2 plastic scribe 3 indent

3Starting on the right side of the computer, use a plastic scribe to pry up the hinge cover. Lift the cover away from the computer going from the right toward the left, and lay the cover aside.

4To replace the hinge cover, insert the left edge of the cover into place.

5Press from left to right until the cover snaps into place.

118

Adding and Replacing Parts