FX160/400ECO GB
Troubleshooting
PROBLEM |
| CAUSES | REMEDY |
The | • | the power is off |
|
does not work | • | the appliance is not plugged in | • Plug it in |
(Mod. FX160ECO). The
• The exhaust hose is twisted | • Position exhaust hose correctly | ||
• | The exhaust hose is blocked | • | Check for obstacles blocking |
|
|
| the exhaust system |
• | The exhaust hose is bent | • | Straighten the hose |
The
• a window is open | • | close the window |
• there is a source of heat in the room (lamp, | • eliminate source of heat | |
burner etc.) or there are many people in the |
|
|
room. |
|
|
• the thermostat is set too high | • set the thermostat to a lower | |
|
| temperature |
• air filters are dirty | • | clean/replace filters |
• the capacity of the |
|
|
adequate for the conditions or the dimen- |
|
|
sions of the room. |
|
|
Strange odour in the | • air filters are dirty | • clean/replace filters |
room |
|
|
|
|
|
Leaking condensa- | • appliance incorrectly installed | • see instructions for correct |
te from the unit |
| installation of appliance |
| • condensate collection tank is full | • Mod. FX160ECO: empty the |
|
| tank |
|
| Mod. FX400ECO: drain the |
|
| water through the drain tube |
|
| found at the rear of the |
|
| appliance. |
The unit does not work • The safety mechanism has been activated | • wait for 3 minutes |
for about 3 minutes |
|
after turning on the |
|
appliance. |
|
|
|
See paragraph “Self diagnosis” if the following messages appear on the display: FF, HP, LT, FT, PF.
34