DeLonghi T t i n g u p Mod. FX400ECO, Preparing the Internal Unit, Using the Quick Couplings

FX160/400ECO GB 20-06-2002 16:51 Pagina 26

S e t t i n g u p (Mod. FX400ECO)

PREPARING THE INTERNAL UNIT (1)

Install the appliance inside the room to be air conditioned, usually near a window or a peri- meter wall.

The internal unit must be positioned level. Use the wheel blocks (20) supplied. The intake zone (intake grill (8)) and the discharge zone (discharge grill (2)) must be kept clear of obstacles.

NB: Leave at least 30 cm between the wall and the appliance.

POSITIONING THE CONNECTING SHEATH

The sheath connecting the external and inter- nal units can be passed:

a)Through the gap in a window or door left ajar; use the suckers (20) to prevent ope- ning further (fig. 7).

cm	30
		7

USING THE QUICK COUPLINGS

As an alternative to the methods described above, the sheath connecting the external and internal units can be passed through a 6 cm diameter hole in an perimeter wall.

In this case, the external unit couplings must be disconnected as follows:

1)Unplug the appliance from the mains sup- ply.

2)Remove the handle by removing the screw covers and unscrewing the two fixing pins and the two metric screws; then remove the front panel.

	SHEATH CLIP
ELECTRICAL
CONNECTION
BLOCK
PROTECTION	“U”-STAY

9

cm 30

b)Through a small hole made in the bottom of a door or the frame of a window, using the sheath frame (22) supplied (fig 8).

3)Remove the “U” stay by unscrewing the two metric screws (fig 9).

4)Remove the sheath clip (fig 9).

5)Using a 24 mm spanner, undo the rotating connection on the coupling. At the same time, using a 21 mm spanner, hold the end of the flexible tube (fig10). (repeat for the second connection using a 24 mm and a 19 mm spanner)

6)Disconnect the condensate tube from the pipe fitting.

8

cm 30

10

26