|
| C |
| D | D |
|
| |
|
| B |
A |
| A |
|
| Fig. 29 |
NOTE: Shown from the rear, Fig. 30 illustrates the sliding plate position and bushing (C) adjustment for 45° left and Fig. 31 illustrates the sliding plate position and bushing (C) adjustment for 45° right.
MAKE SURE THAT THE FENCES ARE
CLEAR OF THE GUARD AND BLADE
BEFORE OPERATING THE SAW.
C
Fig. 30
C
Fig. 31
ADJUSTING THE BEVEL LOCK
The
ADJUSTING SLIDING FIT BETWEEN TRUNNION AND BEVEL BRACKET
After a period of time, it may become necessary to adjust the sliding fit between the trunnion and the bevel bracket by tightening the adjusting nut (C) Fig. 33 at the rear of the tool.
Correct adjustment provides a snug sliding fit between these two parts. This adjustment should not be so tight that it restricts the tilting movement of the trunnion when bevel cutting, or so loose that it affects the accuracy of the saw cut.
ADJUSTING THE TENSION OF CUTTINGHEAD RETURN SPRING
The tension of the cuttinghead return spring has been adjusted at the factory so that the cuttinghead returns to the “up” position after a cut has been made. To
(B) Fig. 34 clockwise to increase, or counterclockwise to decrease the spring tension. Tighten nut (A) securely.
A
C
Fig. 33
A
B
Fig. 34
ADJUSTING SLIDING FIT BETWEEN CUTTINGHEAD ARM AND TRUNNION
After a period of time, an adjustment of the sliding fit between the cuttinghead arm (B) Fig. 35, and the trunnion (C) may be necessary. To adjust, tighten or loosen the nut (D). Correct adjustment provides a snug sliding fit between these two parts. This adjustment should not be so tight that it restricts the sliding movement of the cuttinghead arm (B) or so loose that it affects the accuracy of the saw cut.
14
