ADJUSTING FENCE
POSITIVE STOP
NOTE: SWITCH HAS BEEN REMOVED FOR CLARITY OF ILLUSTRATIONS ONLY.
The fence on this jointer is equipped with positive stops that allow you to rapidly tilt the fence to the 90 and 45 degree angle to the table in the inward or outward position. To check and adjust the positive stops, proceed as follows:
D I S C O N N E C T M A C H I N E F R O M
POWER SOURCE.
1. | Position the fence at 90 degrees to the table. Make |
certain flip stop (G) Fig. 51, is in the lowered position as | |
shown, and adjustment screw (A) is contacting the flip | |
stop. Then tighten lock handle (B). | |
2. | Place a square (C) Fig. 51, on the table and against |
the fence to determine if the fence is 90 degrees to the | |
table. | |
Fig. 50
C
D A
3. | If an adjustment is necessary, loosen lock handle (B) |
Fig. 51, and lock nut (D). Turn adjustment screw (A) until | |
you are certain the fence is 90 degrees to the table. Then | |
tighten lock handle (B) and lock nut (D). | |
4. | Loosen lock handle (B) Fig. 52, and rotate flip stop |
(G). Then tilt fence out as far as it will go and tighten lock | |
handle (B). | |
5. | Using a square (C) Fig. 52, check to determine if the |
fence is 45 degrees to the table, as shown. | |
6. | If an adjustment is necessary, loosen lock handle (B) |
Fig. 52, and lock nut (E). Turn adjustment screw (H) until | |
you are certain the fence is 45 degrees to the table. Then | |
Fig. 51
H E
G
B
G
B
tighten lock handle (B) and lock nut (E). | |
7. | Loosen lock handle (B) Fig. 53, and tilt fence as far |
in as it will go and tighten lock handle. | |
8. | Using a square (C) Fig. 53, check to determine if the |
fence is 45 degrees to the table. | |
9. | If an adjustment is necessary, loosen lock handle (B) |
Fig. 53, and lock nut (J). Turn adjustment screw (K) until | |
you are certain the fence is 45 degrees to the table.Then | |
tighten lock handle (B) and lock nut (J). | |
C
Fig. 52
J K
B
C
Fig. 53
17
