Delta 37-195, 37-275X instruction manual Locking Switch OFF Position, Infeed Table Adjustments

LOCKING SWITCH

IN THE “OFF” POSITION

IMPORTANT: When the tool is not in use, the switch should be locked in the “OFF” position to prevent unauthorized use. Insert the shank of padlock (C) Fig. 33, through the holes in the switch plate to lock the on/off switch trigger (A).

INFEED TABLE

ADJUSTMENTS

1.To raise or lower the infeed table, loosen table lock handle (A) Fig. 34, located on the rear side of infeed table.

2.Grasp the infeed table raising/lowering handle (B) Fig. 35, and squeeze locking lever (C), and raise or lower handle (B).

3.NOTE: When raising or lowering the infeed table, a depth stop (D) Figs. 35 and 36, will automatically stop the table at an 1/8" depth-of-cut. To move the table past this point, the depth stop must be lifted as shown, and the table can be moved up or down.

Always make sure table lock handle (A) Fig. 34, is tightened before operation. The table lock handle (A) is spring-loaded and can be repositioned by pulling out the handle and repositioning it on the serrated nut located under the handle.

C

A

Fig. 33

A

Fig. 34

D

B

C

Fig. 35

4.The depth-of-cut of the infeed table (position of table in relationship with the cutting circle) can be indicated with the pointer (E) Fig. 36. Maximum depth- of-cut is 1/2".

E

D

Fig. 36

13