Jointer Parts | Delta 37-275X, 37-195 instruction

JOINTER PARTS

1

2

3

4

5

6

7

	8
	9			11
						12
						12
				13
		14		15
		14		15
	10

						Fig. 4
1.	Jointer			9.			12-14mm Open End Wrench
2.	Fence Carriage Assembly			10.			8-10mm Open End Wrench
3.	Cutterhead Pulley Guard/Carriage Mounting			11.			8mm Hex Wrench
Bracket				12.			6mm Hex Wrench
				12.			6mm Hex Wrench
4.	Switch Mounting Bracket			13.			4mm Hex Wrench
				13.			4mm Hex Wrench
5.	Cutterhead Guard			14.			3mm Hex Wrench
				14.			3mm Hex Wrench
6.	Fence Tilting Handles (2)			15.			2.5mm Hex Wrench
				15.			2.5mm Hex Wrench

7.Fence

8.Push Blocks (2)

6

Image 6

Delta 37-275X, 37-195 instruction manual Jointer Parts

Contents

Professional Jointer Safety Guidelines / Definitions General Safety Rules Additional Safety Rules for Jointers Refer to them often Use them to instruct others Power Connections Unpacking and Cleaning Extension Cords Jointer Parts Assembly Stand and Electricals Assembling Jointer to Stand Assembling Motor Pulley Adjusting Belt Tension Assembling Belt and Aligning Pulleys Assembling Fence Carriage Assembly Assembling Fence Assembling Switch and Mounting Bracket Assembling Cutterhead Guard Operating Controls and Adjustments Assembling Dust ChuteStarting and Stopping Jointer Locking Switch OFF Position Infeed Table Adjustments Outfeed Table Adjustments Knife AdjustmentsInfeed Table Positive Stops Page Adjusting Table Gibs Fence Operation Adjusting Fence Positive Stop Lock nut D. Turn adjustment screw a until REMOVING, REPLACING, and Resetting Knives Placement of Hands During Feeding OperationJointing AN Edge Taper Cuts SurfacingBeveling Cutting a Rabbet Surfacing Short Or Thin Work Maintenance and RepairsSurfacing Warped Pieces Direction of Grain Pushstick Constructing a Push Stick Accessories Canadian PORTER-CABLE Delta Service Centers