INFEED TABLE
POSITIVE STOPS
D I S C O N N E C T M A C H I N E F R O M
POWER SOURCE.
Positive stops are provided to limit the height and depth of the infeed table. To adjust the stops, loosen two locknuts (F) and (G) Fig. 37, and turn the two adjusting screws (J) and (K) as required. Then retighten the locknuts (F) and (G). A good suggestion is to set the upper positive stop (J) for your finish or final cut. This means that you will be able to rapidly set the infeed table for a finish or final cut without checking the scale and pointer. Also the lower positive stop (K) can be set for the maximum
OUTFEED TABLE
ADJUSTMENTS
D I S C O N N E C T M A C H I N E F R O M
POWER SOURCE.
1.In order to perform accurate jointing operations, the outfeed table must be exactly level with the knives at their highest point of revolution. This means that the knives must be parallel to the outfeed table and project equally from the cutterhead.
2.To move the outfeed table up or down, loosen lock- screw (A) Fig. 38, and turn hand knob (B). When the outfeed table is exactly level with the knives at their highest point of revolution, tighten lockscrew (A).
KNIFE ADJUSTMENTS
In order to do accurate work, the knives must be exactly level with the outfeed table. To check and adjust, proceed as follows:
D I S C O N N E C T M A C H I N E F R O M
POWER SOURCE.
1.Loosen infeed table lock lever and lower infeed table as described under section “INFEED TABLE ADJUSTMENTS”.
2.Remove cutterhead guard (C) Fig. 39.
3.Place a steel straight edge on the outfeed table, extending over the cutterhead as shown in Fig. 40.
4.Carefully rotate the cutterhead by hand. The knives should just touch the straight edge.
G
J
F
K
Fig. 37
A
B
Fig. 38
C
Fig. 39
Fig. 40
14
