ASSEMBLING POINTER
1.Attach right side hairline pointer (UU), Fig. 20 to fence crossarm (VV) Fig. 21 using two
Fig. 20.
2.Screws go through the slotted holes in the pointer and into the threaded holes (XX) Fig. 21 in the crossarm.
3.Keep hardware loose for adjustment procedure.
4.Repeat for the left pointer assembly.
ADJUSTMENTS
ADJUSTING THE FENCE PARALLEL
IMPORTANT: CHECK TO MAKE CERTAIN THAT THE MITER GAUGE SLOTS IN THE SAW TABLE ARE PARALLEL WITH THE SAW BLADE. CHECK WITH THE INSTALLATION MANUAL THAT CAME WITH YOUR SAW FOR INSTRUCTIONS.
To reduce the risk of injury, turn unit off and disconnect it from power source before installing and removing accessories, before adjusting or when making repairs. An accidental
The fence (YY) Fig. 22, must be adjusted so it is parallel to the miter gauge slot (ZZ). Slide the fence until the bottom edge is in line with the edge of the miter gauge slot as shown and push down on fence locking handle (RR) Fig. 21.
Check to see if the fence (YY) Fig. 22 is aligned with the miter slot the entire length of the table. If an adjustment is needed, lift fence (YY) off the guide as shown in Fig. 23.
Slightly tighten or loosen adjusting screws (A1) Fig. 23 or (B1), using a 3/16" hex wrench, not included. Replace the fence on the guide tube and check again. Repeat this adjustment until you are certain the fence is parallel to the miter gauge slot. NOTE: Very little movement of the adjusting screws is necessary to adjust the fence.
WW
UU
Fig. 20
VV
XX
RR
Fig. 21
YY
ZZ
Fig. 22
YY
B1
A1
Fig. 23
11
