Delta 78-055B ATTACHING ACCESSORY DRAWER TO EXTENSION TABLE, ATTACHING HANDLE TO DRAWER, DRAWER STORAGE FOR ACCESSORIES

7
ATTACHING ACCESSORY DRAWER TO
EXTENSION TABLE
Ifyouhavetheaccessorydrawer,removethedrawer(H)
Fig.5fromthedrawerframe(I).Todothisholdrelease
tab(J) and unhookthe drawer’smetalgliderfromthe
frame’s metal glider.
Turn drawer frame (I) upside down (as shown in Fig. 6)
and line up four holes in drawer frame — two shown at
(K)Fig.6—withthefourholes(L)Fig.7inthebottomof
the extension table.
Attach the frame to the bracket using four 1/4-20 x 1/2”
(13mm)hexsocketbuttonheadcapscrewsand1/4-20
flangenuts.Insertthescrewsdownthroughhole(K)Fig.
6 and tighten underneath with flange nut.
NOTE: Do not re-insert drawer until the table is turned
right side up and attached to the saw.
ATTACHING HANDLE TO DRAWER
Hold the drawer handle (N) Fig. 7A up to the holes (M)
and attach handle to the drawer face with two #8-32 x
1-1/2”(38mm)roundheadscrews(notshown).
H
FIG. 5
I
FIG. 6
I
K
FIG. 7
L
FIG. 7C
DRAWER STORAGE FOR ACCESSORIES
Thedrawer(P)Fig.7Ccanholdseveralbladesandmany
of the accessories that come with your Unisaw. P
FIG. 7A
FIG. 7B
N
M
M
J