Delta Electronics VFD-XXXM Parameter, Explanation, Settings, Factory, Customer, English-13

Parameter	Explanation	Settings	Factory	Customer
			Setting
Pr.59	Electronic Thermal	30 to 300 sec	60
	Motor Overload
		00: Over-Torque Detection Disable
		01: Enabled during constant speed
		operation until the allowable time for
		detection (Pr.62) elapses.
	Over-Torque Detection	02: Enabled during constant speed
Pr.60		operation and halted after detection.	00
	Mode
		03: Enabled during acceleration until the
		allowable time for detection (Pr.62)
		elapses.
		04: Enabled during acceleration and
		halted after detection.
Pr.61	Over-Torque Detection	30 to 200 %	150
	Level
Pr.62	Over-Torque Detection	0.0 to 10.0 seconds	0.1
	Time
		00: Decelerate to 0 Hz
Pr.63	Loss of ACI (4-20mA)	01: Stop immediately and display "EF"	00
		02: Continue operation by last frequency
		command
		00: Display AC drive output Frequency
		(Hz)
		01: Display User-defined output
		Frequency (H*Pr.65)
		02: Output Voltage (E)
		03: DC Bus Voltage (u_)
		04: PV (i)
Pr.64	User Defined Function	05: Display the value of internal counter	06
	for Display	(c)
		06: Display the setting frequency (F or
		o=%)
		07: Display the parameter setting (Pr.00)
		08: Reserved
		09: Output Current (A)
		10: Display program operation (0.xxx),
		Fwd, or Rev
Pr.65	Coefficient K	0.01 to 160.0	1.00
Pr.66	Communication	0.00 to 400.0 Hz	0.00
	Frequency
Pr.67	Skip Frequency 1	0.00 to 400.0 Hz	0.00
Pr.68	Skip Frequency 2	0.00 to 400.0 Hz	0.00
Pr.69	Skip Frequency 3	0.00 to 400.0 Hz	0.00
Pr.70	Skip Frequency Band	0.00 to 20.00 Hz	0.00
	PWM Carrier	01 to 15	15
Pr.71		The factory setting of VFD075M43A is 10.
	Frequency
		575V series: 01 to 10	6
Pr.72	Auto Restart Attempts	00 to 10	00
	after Fault

English-13